Document digital input pins

This commit is contained in:
Joris van Rantwijk 2024-10-12 10:49:24 +02:00
parent bcceac91c3
commit d9ff515723
1 changed files with 13 additions and 4 deletions

View File

@ -1,6 +1,11 @@
---
gitea: none
include_toc: true
---
# PuzzleFW FPGA firmware
The PuzzleFW firmware provides the following functionality:
The FPGA firmware provides the following functionality:
* Collect ADC samples at 125 MSa/s with configurable decimation or averaging.
* Trigger on external digital input and collect a configurable number of samples.
@ -12,7 +17,7 @@ The PuzzleFW firmware provides the following functionality:
LED0 to LED7 are the first 8 yellow LEDs from left to right on the side of the Red Pitaya.
LED0 blinks at a rate of 1 Hz when the PuzzleFW firmware is active.
LED0 blinks at a rate of 1 Hz when the FPGA firmware is active.
Its purpose is to provide a minimal indication that the FPGA is active.
LED1 is on when the analog acquisition chain is enabled (register `ACQUISITION_EN`).
@ -213,7 +218,11 @@ It marks the point in the message sequence where an unknown number of messages h
# Timetagger
The timetagger has 4 digital input signals.
If a rising or falling edge occurs on one of these signals, a timestamp is assigned to that event and a message is emitted and transferred via DMA.
If a rising or falling edge occurs on one of these signals, a timestamp is assigned to that event.
Timestamped events are transferred via DMA.
The 4 digital input channels are connected to the digital I/O connector of the Red Pitaya.
Digital input channels 0 to 3 correspond to pins `DIO0_P` to `DIO3_P`.
A 4-cycle glitch filter is applied to the digital input signals.
This filter rejects digital pulses shorter than 4 clock cycles (32 ns).
@ -926,7 +935,7 @@ Therefore, the smallest unit of data transferred via DMA is a 64-bit word.
The size of every DMA transfer is a multiple of 8 bytes, and the address of every transfer is aligned to a multiple of 8 bytes.
(This is an implementation choice in the firmware.
It is possible in principle to transfer smaller amounts of data via the AXI bus, but the PuzzleFW firmware is designed to transfer 64-bit words in all cases.)
It is possible in principle to transfer smaller amounts of data via the AXI bus, but this firmware is designed to transfer 64-bit words in all cases.)
Data are temporarily queued in a FIFO RAM block inside the FPGA until the DMA engine is ready to start a transfer.
This is necessary because DMA operates in bursts, and it may take some time before the DMA engine can initiate a burst.